MKS GEN L V1.0

Name: MKS GEN-L V1.0

  This controller board is integrated which is based  on  Marlin open source,

  greatly compatible with   Ramps1.4. Further, it is good cost effective with high performance.

 
Packing List

  1* MKS Gen-L V1.0     

​  3* Endstop (Or dual Z adaptor)

  1* USB

  1* Screwdriver

Features

• Assembly with high quality MOSFET which is good at cooling and ensure  stable working in a long time.
• Use dedicated  power chip which has excellent cooling and stable electricity.
• Adopt stable and reliable  filter circuit  to reduce  interference. Improve printing performance.
• Highly, improve the MOSFET cooling of heated bed .
• It is easy and safe to assemble motors, drivers and endstops in different color.
• Attention:Please disconnect all parts from the board when upload firmware.

More features as following


Wiring


PINOUT


SIZE


The direction of stepper drivers on boards.



How to Adjust Driver Current.
 
Caution!
Please mind the power polarity and  drivers direction.
Please don’t put the drivers or motors on/off while power on.
Please disconnect all motors when adjust driver current.
 
 
A4988(1amp)
I= vref /1.6,default Vref 1.6V and 0.5A,Max1.0A.
 
A4988(2amp)
I= vref /0.8,default Vref 0.8V and 1.0A,Max2.0A.
 
DRV8825
I= vref *2, default 0.65A and 1.3A,Max 2.5A.
 
LV8729
I= vref /0.5, default 0.4A and 0.8A,Max 1.5A.

Following picture shows how to check the Vref.

Attention,please!

If one of your mainboard or LCD is not  produced by Makerbase or  from us,   

please make one connecting terminal refer to following way.